Week 7 Challenge
- in this week i am importing my door bezel part into my solidworks software
- and then go to mold tools and click on draft analysis and select face 1, and give the draft angle as 0.5 degree. and then click on ok
- then it will change to only red and green colour.
- then goto scale commond and incease the whole part to 0.6%
- after that, click on parting line and select the same face 1 and click on draft analysis then automatically the software is concerning the parting line
- then click on shut-off surfaces and make sure that all parts should be closed. then automatically the part is seperable into core and cavity
- after that, draw slider lines to all possible edges of the part and select respetive edges and click on ok.
- then click on ruled surfaces to make parting surfaces for the part in dffernt directions and in diferent locatos.
- after certain surfaces are made using lofted surface commond connect all surfaces that near to one on one
- then, select all ruled and lofted surfaces then click on knit suface commond and merge all surfaces to one
- make copy of surface and merge the core ,cavity components with respective surfaces by using knit surface commond
- know import the file to new assembly from part, and save it in a seperate assembly folder
- then add 2 new parts and rename them core_steel and cavity_steel folders and save them in same assembly foldr
- after that, get the origin of car bezel body to the sprue location by selecting required planes and meet them with a required distances
- then get th part into sketching mode, and draw the rectangles with proper dimensions . pad it with extruded boss commond with 90 mmm in two directions
- then offset the core surface using offset surface commond, and then click on cut with surface and remove the upper part to get core block.
- the similar procedure is to be followed to get cavity block.