Week 8 - Challenge 6 - Core & Cavity Design

CORE & CAVITY DESIGN CHALLENGE

Introduction-: In this challenge we will be studying & understanding the design intent for mould designing of the plastic component & will be implementing the learnings on designing the Core & Cavity Block for Switch Bezel component.

Switch-Bezel Plastic Component

Core & Cavity Block - Switch Bezel

1. Design of Core & Cavity Block-:

a. Draft Analysis-:

Class-A-

Part Body-

b. Core Block views in different orientation-:

1. Isometric-:

2. Front-:

3. Left-:

4. Bottom-:

c. Cavity Block views in different orientation-:

1. Isometric-:

2. Front-:

3. Back-:

4. Right-:

5. Top-:

d. Parting Surface-:

e. Parting Line-:

f. Core & Cavity Block-: