Week 8 - Challenge 5 - Door Trim Lower

DOOR TRIM LOWER

Aim: To Create the Door trim lower component through the given Class-A surface.

Objectives:

• Creation of Tooling axis with appropriate draft angle.

• Creation of other surfaces (eg, B and C surfaces) for creating a solid component.

• Perform Draft analysis on Class A surface and Solid model hence created.

METHODES:

TOOLINX AXI

• Create a traft angle to givened class A surface.
• This surface tooling axis was create two to three methodes.
• so created the tooling axis is poit to draft angle.

DRAFT ANALYSING

• Creatted the tooling axix to chekkin out to the draft analysing.
• draft analyxing is help to arfast angle check.

CLASS B SURFACE:

• offsrt the class a surface to create the class b surface.
• the offset was get the three patches .
• So define to create all patches to methodw of multiple extract complymantry moode and multiple extract.And extrablate the extracts.
• trim the two R three extrablated surface to get missing surface.
• the same consep to create every missied surfaces.
• and all the created edjes is filletting to get the fine surface.
• finely get the b surface.

CLASS C SUEFACE:

• C surface is help to join the a & B surfaces.
• use the class A surface and get the sweep command .
• the Class A surface is more differant angles.
• so create the boundry offf every flated surfacess are same anguler surfaces.
• same options of every same surface.
• and use the sweep command to get the c surface.
• and trim the all sweeped surface to get the Class C surface.

JOIN:

• join all the surfacess to get the closed surfacecc.
• join the class A and C surface.
• and next to trim the class b surface to get the closed surface.
• but the class b surface is same lenth of the class A surface so didnt trim it.
• So extrablate the class B surface and trim to get the closed surface.

TREE STRUCTURE:

.

DRAFT ANALYSING FINEL:

• Created the closed surface and again once check the draft analysing.

DRAFT WIEWS:

FRONT VIEW

BACK VIEW

TOP VIEW

BOTTUM VIEW

ISOMATRIC VIEW

CONCLUTIONS:

CREATED THE CLASS B & C SURFACE TO THE GIVEN CLASS A SURFACE DORE TRIM LOWER PLASTIC COMPONENT.