Week 8 - Challenge 4 - Bumper

Create the Bumper Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

Take the Thickness of the component to be 3 mm.

SOLUTION:-

Screenshots of the Draft analysis report for both the given Class-A surface and the final plastic component

ISOMETRIC VIEW

FRONT VIEW

SIDE VIEW

TOP VIEW

A detailed report should be done explaining the draft analysis

Draft Analysis is the process in which we can decide whether the class A surface is perfect for moulding or not. The standard draft required is a minimum of 3 degrees in the plastic industry. To check that, we have to create a tooling axis with the help of the given class A surface.

An explanation should be given on the way of creating the tooling axis, particularly the Bisecting method.

Here we have to create a centre point on a flat surface using the point command and then with the help of the line command, we will get out the final tooling axis.