Week 8 - Challenge 4 - Bumper

RIBS CREATION AIM:  To design ribs on the coin holder considering every RIB design rule in the industry. THEORY: Class-B surface contains all the engineer data required for the model to be completed.  Some of the major features of the B-side are: Ribs Screw boss design DRAFT ANALYSIS Draft analysis is a…

BUMPER DESIGN AIM: to make a model from the provided class-A surface. INTRODUCTION: CLASS-A SURFACE: a surface made by the designer which is given as an input to the plastic modeler to work on. It is aesthetic surface and the outer most surface. CLASS-B SURFACE: a surface below a certain thickness from the…

OBJECTIVE : To design the core and cavity for switch bezel and to design the parting surface and parting line for switch bezel. In core and cavity design there are four main things to consider core, cavity, parting surface and parting line. Core and cavity are the two halves of complete mould in which either of them is…

CREATION OF CLASS A, B AND C SURFACES, TOOLING AXIS AND DRAFT ANALYSIS FOR COIN HOLDER OBJECTIVE: The main objective of this project is to create the class A, B and C surfaces, tooling axis and the draft analysis for the coin holder using CATIA V5. Introduction: The tooling axis is very important for the component to be…

  DESIGNING OF BEZEL SWITCH OBJECTIVE The objective of the project is to design the Switch Bezel and to do a draft analysis for it by creating the required tooling axis. INTRODUCTION The switch bezel is the part of a door which holds the switches. Moulding is the method used to manufacture it. STEPS FOR DESIGNING…

  The Draft Analysis command enables you to detect if the part you drafted will be easily removed. This type of analysis is performed based on color ranges identifying zones on the analyzed element where the deviation from the draft direction at any point, corresponds to specified values. When developing parts for…

  SKILL LYNC                           PROJECT REPORT       MODELLING OF YACHT ON SOLIDWORKS             BY, AMIT MINTRI   INTRODUCTION: The project gives the detailed instruction about the designing…

                                                                                          …