Week 8 - Challenge 3 - Coin Holder Design

 Following steps are followed to create the coin holder component and draft analysis have been made on the model.

DRAFTING ANALYSIS:

• tooling axis have been created using bisecting method for class A surface.
• The compass has been aligned with tooling axis and drating angle has been checked.

CLASS B SURFACE:

• The surface are extracted from the A class surface.
• After extraction, the surface is extrapolatee and trimmed together
• Trimmed surface have been offset for the thickness of 2.5mm.

CLASS C SURFACE:

• Sweep command is used to create the surface which joins the Class A and Class B sirface together.
• For sweep usage, boundary command is used to create the boundary, and reference surface has been created from class A surface ising extract command.
• Method used for sweep is refernce surface method.
• Draft angle vaiue is given as 90.
• Finally join command is used to join the surfaces together to form final component.

PART BODY:

• using the command close surface, the surface is transformed into solid.

DRAFT ANALYSIS:

• Again,the draft analysis command is used to analyse the draft for the final component.