Week 8 - Challenge 1 - Base Bracket Design

STEPS FOLLOWED TO CREATE A SOLID USING CLASS A SURFACE

• CREATED A TOOLING AXIS USING BISECTING METHOD BY LINE, PLANE, AND INTERSECTING METHOD.
• DONE DRAFT ANALYSIS 1 FOR CLASS A SURFACE WITH REFERENCE TO TOOLING AXIS
• CLASS B SURFACE
  • STEP 1 : EXTRACTED THE SURFACES FROM CLASS A SURFACE FOR THE DIFFERENT FEATURES FOR RIBS, BASE.
  • STEP 2 : OFFSET THE SURFACES FOR 2.5 FROM THE EXTRACTED SURFACES OR CLASS A SURFACE.
  • STEP 3 : UNTRIM THE SURFACES.
  • STEP 4 : TRIMMED THE SURFACES TO FORM CLASS B SURFACE.
• CLASS C SURFACE
  • STEP 1 : EXTRACT THE BOUNDARY CURVES FROM CLASS A SURFACE BY THE COMMAND BOUNDARY.
  • STEP 2 : SWEPT THE SURFACES FROM THE DRAFTING METHOD BY SELECTING THE BOUNDARY AND TOOLING AXIS.
  • STEP 3 : TRIMMED THE SURFACES OF CLASS A SURFACE, CLASS B SURFACE AND SWEPT SURFACE TOGETHER TO FORM THE CLASS C SURAFCE.
• A SOLID HAS BEEN CREATED FROM THE CLASS C SURFACES USING CLOSE SURFACE COMMAND.
• DRAFTING ANALYSIS FOR THE FINAL COMPONENTS HAVE BEEN DONE FINALLY.
• AS REQUIREMENT IN THE OBJECTIVE OF THE CHALLENGE PUBLICATION HAS BEEN CREATED FOR THE FOLLOWING OF CLASS A, CLASS B, CLASS C SURFACES AND TOOLING AXIS HAVE BEEN CREATED.

SCREENSHOTS HAVE BEEN ATTACHED FOR THE FOLLOWING CHALLENGES BELOW.