Week 8 - Challenge 2 - Switch Bezel Design

steps followed to create the switch bezel component through the given Class A surface.By taking the thickness of the component to 2.5 mm

• tooling axis have been created using the bisecting line method.
• draft analysis have been done on the Class A surface using the tooling direction.
• Class B Surface
  • surfaces have been extracted from the class A surfaces.
  • extracted surface have been untrimmed and surfaces are extended using extrapolation command.
  • surfaces are trimmed and offset to 2.5mm
  • required fillets are created for the final surface
• Class C Surface
  • Boundaries are extracted from the class A surfaces.
  • smooth curve command is used for smoothening the boundary curves to make easy for the sweep command from drafting tool axis.
  • boundary 1 and boundary 2 are trimmed together.
• final component
  • class A, class B, class C surfaces are joined and trimmed together to form a final component with the thickness of 2.5mm
• drating analysis
  • analysis for the final component have been done.

following required files have been attached below.