Week 8 - Challenge 3 - Coin Holder Design

Coin Holder Design:

Objective:

Create the Coin Holder Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

Take the Thickness of the component to be 2.5 mm

Creation of tooling axis:

As the side walls are straight, here we create a straight line from the base surface through the point.

Part Design:

Draft analysis:

The draft analysis is done to determine if the designed part is tool able or not. Here the tooling axis is 3°.

By using the compass option, drag and place it on the tooling axis. Click ok then check the result.

Conclusion:

The part has been designed as per the design requirements.