Week 8 - Challenge 3 - Coin Holder Design

Create the Coin Holder Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

Take the Thickness of the component to be 2.5 mm

SOLUTION:

Screenshots of the Draft analysis report for both the given Class-A surface and the final plastic component

ISOMETRIC VIEW

FRONT VIEW

SIDE VIEW

TOP VIEW

A detailed report should be done explaining the draft analysis

Draft Analysis is the process in which we can decide whether the class A surface is perfect for moulding or not. The standard draft required is a minimum of 3 degrees in the plastic industry. To check that, we have to create a tooling axis with the help of the given class A surface.

An explanation should be given on the way of creating the tooling axis, particularly the Bisecting method.

Here we have to create a centre point on a flat surface using the point command and then with the help of the line command, we will get out the final tooling axis.