Week 8 - Challenge 2 - Switch Bezel Design

REPORT OF DRAFT ANALYSIS AND THE TOOLING AXIS CREATION:

TOOL AXIS CREATION:

INITIALLY MAKE A POINT WITH RESPECT TO CLASS A SURFACE. AFTER THAT CREATE THE DUMMY AXIS LINE USING SKETCH WITH RESPECT TO THE SIDE WALLS.

THEN MAKE AN 3 DEG ANGLED LINE USING SKETCH WITH RESPECT TO OTHER SIDE OF THE WALLS.

AFTER THAT CREATE TOOLING LINE BY USING BISECTING OF TWO LINES WE CREATED WITH RESPECT TO TWO SKETCH LINES WITH POINT AS REFERENCE.

DRAFT ANALYSIS:

SELECT THE SURFACE TO CHECK THE DRAFT ANALYSIS AND OPEN FEATURE DRAFT ANALYSIS OPTION, THEN DRAFT ANALYSIS WINDOW WILL BE OPENED AND THERE WE CAN USE COMPASS OPTION TO DEFINE THE DRAFT DIRECTION. THE DRAFT ANGLE SHOULD BE BELOW 3 DEG. IF THE SUFACE IS SHOWN IN GREEN WHICH MEANS THE SURFACE IS DRAFT ANALYSED. IF NOT IT WILL BE SHOWN IN BLUE COLOUR. WE CAN CHOOSE INVERSE THE DRAFT ANALYSIS OPTION TO MAKE IT GREEN. AFTER THAT PRESS OK. WHICH MEANS THE SURFACE IS DRAFT ANALYSED.

DRAFT ANALYSIS SCREENSHOT

ISOMETRIC VIEW

FRONT VIEW

SIDE VIEW

TOP VIEW