Week 8 - Challenge 2 - Switch Bezel Design

TOOLING AXIS IS USED TO GET A PROPER MOLD DIRECTION.

INCORRECT TOOLING AXIS REPRESENTS INCORECTION MOULDING PROCEDURE RESULTING IN DEFECTIVE PRODUCTS.

BEFORE WE HAVE TO ANALYZE IN WHICH DIRECTION THE COMPONENT IS EASIER TO MOULD AND MOST OF THE AREAS ARE VISIBLE.

EXTRACT THE SURFACE AND CREATE A PONT IN CENTRE AND HIDE SURFACE AND UNHID E CLASS A.

CREATE AXIS SYSTEM AT THE POINT AND GO TO POSTIONED SKETCH.

INTERSECT THE CLASS A.

WE GET A BOUNDARY AND DRAW TWO LINE AND BISECT THEM. AFTER LINE 1 IS FORMED

MAKE BOUNDARIES AND TWO LINES AS REFERENCE.

CREATE ANOTHER PROJECTION IN ANOTHER DIRECTION.

DRAW A LINE ON THE PROJECTION. DRAW A LINE (LINE 2) PASSING THROUG CENTRE AND AFTER DIMENSION ANGLE USING CONSTRAINT.

CHANGE THE ANGLE TO MINIMUM DRAFT ANGLE OF 3 DEGREE.

EXIT WORK BENCH AND BISECT LINE 1 AND LINE 2.

WE GET THE TOOLING AXIS.

ANALYZE THE TOOLING AXIS IN NORMAL VIEW FOR VISIBILITY OF EVERY SURFACES AND PATCHES.

THE USE 0F TOOLING AXIS IS IN DRAFT ANALYSIS

BEFORE DRAFING ANALYSIS CUSTOMIZE THE SURFACE WITH CUSTOMIZE VIEW PARAMETERS AND FURTER WITH MATERIAL SELECTION.

INSER < ANALYSYS < FEATURE DRAFT ANALYSYIS.