Week 8 - Challenge 1 - Base Bracket Design

AIM:

The main aim is to create the Base Bracket Plastic component through the given Class-A surface.

OBJECTIVES:

The main objective is to begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and to create a class B surface and Class C surface and at the end perform the Draft analysis on the model.

INTRODUCTION:

In this project we have designed a base bracket component.Firstly we have created a tooling axis and draft analysis was done maintainig a draft angle of more than 3 degrees for given Class A surface.Later we have designed Class B and Class A surface and finally we have done Draft analysis for the plastic component.

ANALYSIS OF CLASS A SURFACE:

Next finding tooling axis for Class A SURFACE

Next draft analysis done for 3 degrees angle

CREATION OF CLASS B SURFACE:

CREATION OF CLASS C SURFACE

FINAL CLASS A+CLASSB+CLASSC SURFACE

CLOSE SURFACE FEATURE:

DRAFT ANALYSIS ON FINAL COMPONENT: