Week 8 - Challenge 1 - Base Bracket Design

Aim: To create a Base Bracket Plastic Component through a given Class A Surface and perform Draft Analysis on the final plastic component.

Objectives:

• Creation of Tooling Axis.
• Creation of Class B and Class C surface.
• Draft Analysis of Class A surface and final plastic component.
• Creating a solid part out of surface modelling.

CLASS A SURFACE OF THE BRACKET

CREATION OF TOOLING AXIS

This is the surface and YZ plane intersection boundary line. From the pont to point command in line the lines are extended for bisecting and to create the tooling axis.

TOOLING AXIS

DRAFT ANALYSIS FOR SURFACE A

3 degree of draft is been given to the surface.

CREATION OF CLASS B SURFACE

CREATION OF CLASS C SURFACE

FINAL TRIM OF CLASS A,B,C

DRAFT ANALYSIS OF FINAL PLASTIC COMPONENT

ISOMETRIC VIEW OF THE CLOSED SURFACE

FRONT VIEW

TOP VIEW

SIDE VIEW

SKETCH SOLVING STATUS