Week 7 Challenge - Assembly Workbench

Shanil kumar k s 27/9/2023   Table of contents 1.Introduction 2.design process 3.Specifications 4.Analysis and Validation 5.Challenges and solutios 6.conclution   1.Introduction the report documents the design and analysis of the Quick return mechanims and CV joint by using CATIA V5. 2.Design process the assembly was created…

                                                          WEEK 12 - FINAL PROJECT                           …

1. Identify each of the major elements in the above automotive wiring diagram. Battery Starter Distributor Fuse box Ignition coil Current and voltage regulator Generator   2.Explain the purpose and working of any three elements briefly. Battery the battery is he heart of the automotive electrical system. It provides electrical…

                                                       A PILLAR DESIGN WITH MASTER SECTION   AIM To develop the A Pillar Design, I used the master section as the intersecting…

                          DESIGN OF DOOR TRIM LOWER WITH ENGINEERING FEATURES 10/18/2023 Shanil kumar K S   OBJECTIVE The primary objective of this task is to generate a 'Door Trim Lower' solid body utilizing the closed surface technique through the 'Generative Shape Design' workbench in CATIA V5. Additionally, conducting…

                                      ATTACHMENT FEATURE CREATION (DOG HOUSE)   14/10/2023 Shanil kumar K S   TABLE OF CONTENTS 1.Introduction 2.methodology 3.Analysis and Validation 4.Specifications 5.conclution   1. INTRODUCTION This report outlines the design and creation of a Dog house for the Door trim , adhering…

                                                          RIBS AND SCREW BOSS 11/10/2023 Shanil kumar K S   TABLE OF CONTENTS 1.Introduction 2.methodology 3.Analysis and Validation 4.Specifications 5.conclution   1. INTRODUCTION This report outlines the design and creation of a rib and a screw boss for the Drill Handle,…

                                                                 BUMPER DESIGN   9/10/2023 Shanil kumar K S   TABLE OF CONTENTS 1.Introduction 2.methodology 3.Analysis and Validation 4.Specifications 5.conclution   1. INTRODUCTION This report presents the results of the draft analysis conducted on the Bumper Plastic component.…

                                                 CREATION OF THE SWITCH BEZEL DESIGN 6/10/2023 Shanil kumar K S   TABLE OF CONTENTS 1.Introduction 2.methodology 3.design process 4.Specifications 5.Analysis and Validation 6.conclution 1. INTRODUCTION This report describes the steps involved in creating the Switch Bezel…

                                    CREATION OF THE BASE BRACKET PLASTIC COMPONENT 4/10/2023 Shanil kumar K S   TABLE OF CONTENTS 1.Introduction 2.methodology 3.design process 4.Specifications 5.Analysis and Validation 6.conclution   1. INTRODUCTION This report presents the results of a draft analysis performed on the…