Week 4.2: Project - Transient simulation of flow over a throttle body
Week 4.2: Project - Transient simulation of flow over a throttle body
Setup and run transient state simulation for flow over a throttle body.
Post process the results and show pressure and velocity contours.
Show the mesh (i.e surface with edges)
Show the plots for pressure, velocity, mass flow rate and total cell count.
Also show the calculations on how you calculated an end time for the simulation.
Create an animation in which it throttle movement should be visible.
- Upload an animation on You tube and provide the You tube link for an animation in your report.
Answer
The geometry have no change from the previous challenge
The geometry is
The Boundary Conditions
Setting the deflection
The out put files
Running the simulation on Cygwin
After which the files are then converted to Paraview readable format using Converge.
Results on Paraview
the velocity contour when the throttle body is fully opened
Pressure contour when the throttle body is fully opened
Density contour when the throttle body is fully opened
Line Plot
Total Pressure at the outlet
Mass Flow rate at the outlet
Velocity at the outlet
Total cells
Animations - Youtube Videos
Density
Pressure
Velocity