Week 11:- 2D Detailing Challenge 2

To create 2D drawing for each Clamp Units with all child parts and also create Child part drawing for the same for the Fixture assembly created in challenge 8 and to create 2D drawing for each Pin Units with all child parts and also create Child part drawing for the same for the Fixture assembly created in challenge 8.

1) Clamp Unit Detailing

The various clamp units that were used in the fixture assembly were detailed, by first making a key sheet of the clamp unit assembly and then detailing each child part of it.

Key sheet Detailing

Child Parts Detailing for Clamp Unit

Riser:

L-Block:

Rest Mylar:

Clamp Mylar:

Cylinder:

Shims:

2) Pin Unit Detailing

Key Sheet Detailing

Child Parts Detailing for Clamp Unit

Riser:

Pin:

Pin Retainer:

L-Block:

Shim:

The remaining clamp and pin unit detailing is attached below.

Conclusion: The detailing of the various clamp and pin units were done as per the required standard.