Week 10- Assembly Workbench

Aim  To create the flatten for the  harness assembly and place the flattened view on the drawing sheet. Ensure the bundles with protective coverings . Objectives  To create the harness assembly  To open the flatten product and gives the required parameters.  To open the drawing sheet and place…

AIM   To create the  harness assembly in electrical workbench Objective  To make the assembly product  To check the bundle connectivity  To solve the bundle warning  To generate the CAT.part of assembly and convert into .igs format.  To add the annotations for all connectors. Creation of harness assembly Download the required…

Aim  To create the electrical wiring harness routing for the montioned connectors and also give the protection for the wiring bundles. Geometrical bundle This is the sub level product file is the wire  harness product that contains all of harness component i.e clips,supports,connectors,splies,grommets,annotation…

Aim   To define the given part as electrical support and give necessary properties. Clips  this is another important component of wiring harness which should be defined before wiring harness routing . Defining steps for clips Get the clip 3d part Define the geometry parameters Define part as support Define…

 Aim   To define the given connectors electrically amd define the necessary properties to the connector and clip. Wiring harness   Wiring harness is the assembly of wires ,connectors,terminals,protection coverings, insulations,clips,clamps,fause and relay box,retention devices,u guiding channels,electronic…

                                                           FINAL PROJECT - ( DOOR TRIM ) AIM   To create the plastic door body with proper attaching features , from the given class A surface and master sections. OBJECTIVES  To creatre the thickened body .  To create the tooling axis for each part body.  To perform the…

                                                                                                       ASSEMBLY WORKBENCH  MODEL 1 ( Quick return mechanism )  Quick return mechanism is an apparatus is used to create the reciprocating motion in which the tim taken for travel in return stroke is lesser than in the forward…

                                         A pillar design with master section  Aim  To create the  A pillar solid body with respect to the given master section . Objectives  To create the tooling…

                                        DOOR TRIM WITH LOWER ENGINEERING FEATURES AIM   To create the door trim lower component from the given class A surface and create the engineering features ( heat stakes and…

                                          ATTACHMENT FEATURE CREATION CHALLENGE -2 Aim   To create the dog house on the plastic component . Objective   To create the tooling axis for the main core…

                                                                                           …

                                                                                           …

                                                                                        BUMPER …

                                                                                           …

                                                                                           …

                                                                                            BASE BRACKET DESIGN  AIM :   T create the class B and class C surfaces fron the given class A surface, and performing the draft analysis on the given class A surface and the final componenent . Objectives :  Creation of class A…

                                                                                                                        BACKDOOR CHALLENGE AIM    To design a backdoor and provide the necessary embosses and reinforcements by usiing given styling surface. Backdoors  Backdoor/tailgate is the rearmost vehicle of the car design…

                                                                                                                 ROOOF CHALLENGE AIM     To create an assembly by developing the essential flanges for The outer roof and create the reinforcements.   ROOF DEFINITION      An automobile roof or car top is the portion of an automobile…

                                                                                           …

                                                                                                                                 FENDER DESIGN AIM    To create mount area for sill,drip,bumper,baffle(splash) abd drip area for the fender as per the given master diagram. DEFINITION    Fender is a part of car,truc,motor cycles…

                                                                                           …

                                                                                           …

                                                                                           …

 BENCHMARKING       It is the process where we measure our company success against other similar companies to discover if there is a gap in performance that can be closed by improving our performance . Studying other companies can highlight what it takes to enhance our company efficiency and become…