To Generate seismic loading based on IS code and to run the analysis using TSD

1 ) ACCORDING to IS CODE WE HAVE THE VALUES TO PRE DETERMINED WHILE USING THE SEISMIC CALCULATION.

We must know the basic information related to the buildings that have been located and soil data, site class, important factor, and zone factor because these parameters are very important to proceed with the seismic calculation.

For the effective seismic weight, we must consider all the load cases and for the live loads, we need to modify the scale factor-based IS code which is classified into two categories which the live load is more or less than 3kN/m2.

2) After running the analysis we must check the Load is acting correctly, for example, the axial load at the ground level it should be maximum and at the top level, it should be minimum.