Radar Mast & Final Assembly of Yacht

OBJECTIVE :

To model every part of the Sunseeker in solidworks

INTRODUCTION :

This project is about modeling parts of the Sunseeker and assembling it using Solidworks

PROPELLER :

Propeller is used to push the water and to navigate across the ocean. Commands used to model the propeller are Spline, Circle, Line, Revolve, Loft, Extrude, Reference Plane, Circular Pattern, and Fillet.

RADAR :

the uesd to detect another boat signals

BluePrint Setup :

The BluePrints of the front, back, top, bottom, and side views of the Sunseeker Predator

Hull:

Hull is the body of the sunseeker it is the part that which float on the water

Garage Door :

The garage door closes the garage and safeguards your automobiles. Commands used to model Garage door are Line, Spline, Circle, Text, Extruded Cut, Reference Plane, Fillet, Shell, and Mirror.

Seats :

There are three seatings front middle and rear seat Commands used for modeling of seats are SketchPicture, Line, Spline, Circle, Arcs, Extruded Surface, Lofted Surface, Trim Surface, Filled Surface, Knit Surface, Swept Surface, Revolved Surface, Extruded Cut, Revolved Boss/Base, Chamfer, Fillet, Mirror, Dome.

SUPERSTRUCTURE :

The superstructure is the cabin where the entire control Commands used to model the Superstructure are Sketch Picture, 3D Sketch, Line, Spline, Circle, Rectangle, Center Point Arc, Extruded Surface, Swept Surface, Ruled Surface, Knit Surface, Trim Surface, Extend Surface, Filled Surface, Lofted Surface, Revolved Surface, Fillet, Chamfer, Project Curve, Reference Curve, Convert Entities, Split, Split Line.

RADAR MAST :

It is the complete assembly of the radar system which protects from harmful things

ASSEMBLY :

It is the complete view of our Yacht. All the above-mentioned parts are joined together in this assembly.