Project - Data Handling and Interpolation

ANS(1) we have to define all the necessary properties . so firstly we have to define points on both sides of the p clamp. After that we have to define plane on both sides of Pclamp. both the commands are in part design workbench. and a refrence plane is also needed.   After defining points and planes we have to switch…

ans. first i have to download two connectors and aone clip from the given files. after downloading it from the files i have to extract the files .and then i have to define this electrically     this is DT06-8SA connector.. for defining this conncetor electrically i have to go to part design workbench to give point and…

ANS..  Objective: To model and simulate a 10 cells in series lithium ion battery pack, analyze the thermal effects and compare its life cycle performance at various temperatures, charge & discharge rates using MATLAB. Theory: The lithium-ion batteries are widely used as energy sources in different hybrid and electric…

ANS.  Part 1: Simulate the 3 test cases from harness dashboard and write a detailed report on the results. The Closed Loop Harness Dashboard model by Mathworks is as shown below.   To select one of the 3 test conditions, it can be selected via the Test Sequence Variant block which allows you to select which test needs…

ANS..   OBJECTIVE: Prepare a detailed battery pack drawing along with its enclosure.  THEORY:   The high voltage battery is one of the most important components of a battery electric vehicle (BEV). The battery parameters have a significant influence on other components and attributes of the vehicle, like: maximum traction…

 ANS(1). LITHIUM ION BATTERIES: A lithium-ion (Li-ion) battery is an advanced battery technology that uses lithium ions as a key component of its electrochemistry. During a discharge cycle, lithium atoms in the anode are ionized and separated from their electrons. The lithium ions move from the anode and pass through the…

AIM:   Development of a forward energy-based fuel consumption model of a P1 hybrid vehicle.    Tabulate the fuel economy numbers (kmpl) for UDDS and HWFET cycle. Compare these numbers with the baseline numbers for conventional vehicle model from Project 1. Plot the time trace for engine, transmission…

AIM.  The task of this project is to compute the fuel economy numbers for the given vehicle (kmpl) on the urban cycle (UDDS) and highway cycle (HWFET). Also, to analyze and understand the vehicle operatingpoints in terms of engine speed, torque, transmission speeds, pedal positions, gear, distance traveled, etc.…

ANS...The Double-Acting Hydraulic Cylinder block in the scissor hoist contains mechanical and hydraulic subsystems. The mechanical subsystem models the piston and barrel. A Prismatic Joint block provides the translational degree of freedom needed for piston extension and retraction. The piston's range of motion is constrained…

ANS(1).defining the parameters of dc motor is the first thing to do.then find jacobian matrices with the state space model  and find the gains with that jacobian matrices. stop time=10.0sec use step block for supply voltage as ste time and initial value as 0(zero) and final value as 230. using the PID controller in…

  ans(project).. X= xlsread("VI.xlsx");                          %reading data from a text file V= X(:,1);                                         …

kindly find the below pdf attachment for you refrence