Project-2-Meshing of Door Inner Panel Challenge

Aim:-

Follow the Quality Criteria and mesh the following component and assign thickness:

Target Element Length = 4 Units

S.N	Quality Criteria	Value
1	Aspect Ratio	5
2	Skewness	45
3	Warping	15
4	Taper	0.5
5	Min. Length	2 Units
6	Max. Length	6 Units
7	Min angle Quad	45
8	Max angle Quad	135
9	Min angle Tria	20
10	Max angle Tria	120
10	Tria %	10

Object:- Create midsurface and mesh of given component according to given quality criteria.

1.Geometory cleanup:-

1. First upload the model in hyperwork and go topo(when you use by topo you see your geometry look like transprent green that means it's solid you can convert it into surface using delete>solid option) or wireframe mode. To check missing or free cons .
2. As you see above there are some surface miss then, we use surface edit >ruled option to create surface here.
3. And like this,we use many options to clean the geometry as replace,extrect,cut,spline,ruled,defeature,toggle etc.
4. Now we chack our geometry here any free adges or not,then we use wireframe command.

2.Midsurface:-

1. Now we take a mid surface so we can use both command either offset or automid.
2. Geo>midsurface>automid>offset+plane+sew...

3. Meshing:-

1. Before taking mesh we set criteria file.

After set all criteria, we go 2D>automes>and select the whole surface and create mesh.you can go with part by part.

4.Element cleanup:-

1. After creating mesh,we do  fix faile element using cleanup tools.
2. 2D>quality index (place node,element optmize,split/collaps,smooth,edit element etc).

Conclusion:-

• I try to reduce tria in this project and fix fail element.
• I'm learn how to use quality index option to fix element.