Project 1 - Meshing of Floor Panel

AIM:-

Follow the below-mentioned quality criteria, mesh the component given below, and assign thickness:

Target Element Length = 5 Units

S.N	Quality Criteria	Value
1	Aspect Ratio	5
2	Skewness	45
3	Warping	15
4	Taper	0.5
5	Min. Length	2 Units
6	Max. Length	8 Units
7	Min angle Quad	45
8	Max angle Quad	135
9	Min angle Tria	20
10	Max angle Tria	120
10	Tria %	10

Object:- Achive a mid surface and smooth mesh flow of given project.

1. first of all load file in softwear and give topo.
3. and chack geometry,if found any issue then fix it and do geometry cleanup.
4. after that you take mid surface using different tools like-offset,middle,skin etc.
5. And perform meshing using Best,free,spot etc.

    7. To make smooth mesh flow use reconstruct,smooth.

   8. To redused tria use split,swap,past etc.

Conclusion:- I am trying to do smooth mesh,and try to overcome tria and off element.

I am take bach mesh because it's a less time taker other then option like best, spot etc.