Project 1 _Creating an Architectural plan for the provided plot size and develop relevant basic structural drawings

AIM:
To draw draft layout of a residential building

COMMANDS USED:
layer
line
offset
trim
extend
hatch
dimlinear
text
multileader

PROCEDURE:

COMMAND:UN
Set the units to engineering
COMMAND:LIMITS
Specify first corner point:0,0
Specify end corner point:500,500
Select layer properties
Create layers

1.PLAN:
COMMAND:LINE
Specify first corner point
Specify next corner point:60'
Specify next corner point:20'
Close
COMMAND:O
OFFSET
Specify the distance:9''
Internal wall thickness:4.5''
Using offset,trim,extend create the plan as per dimension
COMMAND:LINE
Specify first corner point:
Specify next corner point:12''
Specify next corner point:12''
Column size is taken as 12''x12''
COMMAND:HATCH
AR-CONC
Filled in columns
Windows are provided
W1    6'-4.8''X4'
W2    2'-11.3''X4'
W3    3'-8.1''X4'
V       1.9'X1.9'
COMMAND:Dtext
Mention the required data
COMMAND:dimlinear
By using line type cut the plan by dashed line

2.SECTION
Create sectional view by line,offset and trim
Provide windows as per plan
Provide parapet wall
Using text command give section name

3.ELEVATION
Create elevation by using line,offset,trim
Provide doors and windows as per plan
Provide parapet wall

2.STRUCTURAL DRAWINGS :

1.COLUMN LAYUOT:
Select all columns copy them and place them in different location as shown in figure below
Select the line type  as ISO  02W100 and adjust the scale
Draw the lines through mid point of the columns in both horizontal and vertical direction
Select trim tool and trim unwanted lines
Select the dimension and give the dimensions
Select text, give text height as 8'',give text as per requirement

2.BEAM LAYOUT:
Select the copy option 
Select all the columns from the plan copy them to a different location
Select linetype as ISO02W100 adjust the scale
Draw the lines through mid points of the column in both horizontal and vertical direction
Select trim tool and trim unwanted lines
Select the offset 
Specify offset distance as 4.5'' create offset
Select trim tool and trim unwanted lines
Select the dimension and give the dimensions
Select text, give text height as 8'',give text as per requirement

3.FOOTING PLAN:
Select the copy option 
Select all the columns from the plan copy them to a different location
Using line command the square size of footing 4'x4' provided for all columns
Using line type grid lines are provided
Select text command mention the name
Select dimlinear give dimension