Creating Kitchen layout, Hatching of Architectural elements and sectional view of an Industrial Building in AutoCad

AIM :
To create the kitchen layuot ,use proper dimension techniques and also insert wherever required

COMMANDS USED :
RECTANGLE
LINE
OFFSET
FILLET
HATCH
CIRCLE
DIMLINEAR
TEXT

PEOCEDURE :

Command:UN
UNITS
units are set in mm
Command:limits
specify first corner point:0,0
specify first corner point:100,100
Command :z
zoom all
Command: REC
specify first corner point:
rectangle is drawn as per dimension
Command:offset
distance:230mm
Command:F
Fillet all the edges
Draw A1 to A9 as shown in fig
Command :H
Hatch type ANS132
Select internal place where to hatch
Select the type of hatch
Fill the boundaries 
Give text as shown in fig.

AIM :
To create elevation and hatching the structural and non structural elements of the building like walls,columns etc.

COMMANDS USED:
LINE
RECTANGLE
HATCH
TEXT
DIMLINEAR

PROCEDURE:

COMMAND :L
Extend the lines from the plan in the downward to create projections
COMMAND :O
Specify the distance :150mm
COMMAND :O
Specify the distance :2450mm for ground floor
COMMAND :O
Specify the distance :2850mm second floor
COMMAND :O
Specify the distance :2850mm for third floor
COMMAND :O
Specify the distance :1000mm parapet wall
COMMAND :O
Specify the distance :2500mm
Select multiline text for naming of the section
Command:H
Hatch brick wall with hatch type as brick 
Hatch type AR-CONC 
Command :TEXT
Give text as per required

AIM :
To create the sectional view of an industrial building.

COMMANDS USED: 
LINE
CIRCLE
TEXT
HATCH
DIMLINEAR
QLEADER

PROCEDURE :

Command:L
Specify the frist point:
Specify next point:5850mm
Specify next point:5315mm
draw rectangle by given dimension
Command:O
Specify the distance:300mm
Command:LT
Select dotted line
Command:H
Hatch type as AN-CONC
Command:Mt
give text wherever required
Command:C
Draw the circle,give the text
Give the dimension as shown in fig.