Challenge

Project 1 _Creating an Architectural plan for the provided plot size and develop relevant basic structural drawings

1) AIM:TO CREATE THE FLOOR PLAN AS PER THE GIVEN DETAILS.

INTRODUCTION : THE GIVEN FLOOR PLAN CONTAINS THE 3 BEDROOMS WITH CONNECTED BATHROOMS,HALL,BALCONY ETC.

PROCEDURE:

GO TO START MENU,SELECT INSTALLED AUTO CAD VERSION LIKE 2023.
CLICK ON START DRAWING.
GO TO CREATE NEW DRAWING.
THEN NEW TAB WILL OPEN AND IT SHOWS FOUR ICONS.
USE THE DEFAULT METRIC SETTINGS
OPEN THE TEMPLATE AS ACAD.DWT
THEN NEW DRAWING TEMPLATE IS CREATED AND SET THE LIMITS AND PRESS ENTER.
THEN WRITE ZOOMIN IN COMMAND TAB AND PRESS ENTER,TEMPLATE IS CREATED .
USING UNITS IN COMMAND TAB,SELECT THE UNITS YOU ARE GOING TO DRAFT.
WRITE LINE IN COMMAND TAB AND PRESS ENTER.
PLACING THE COLUMNS OF GIVEN SIZE ON SHEET.
BY ASSUMING WALL THICKNESS EXTERNAL 230MM AND INTERNAL 100MM.
BY USING THE LINE COMMAND AND TAKING THE COLUMNS REFERENCE ,CREATING THE GIVEN ROOMS.
AFTER CREATING THE ROOMS USING TEST COMMAND WRITING THE NAMES OF ROOMS.
CREATING THE DOORS IN THE REQUISITE POSITION USING CIRCLE COMMAND FOLLOWED BY TRIM COMMAND TO OBTAIN DOOR SHAPE.

RESULT:BY FOLLOWING THE ABOVE PROCEDURE THE TABLE CONTAINING THE DIFFERENT CONTENTS IS OBTAINED.

AIM:TO CREATE THE BEAM FRAMING PLAN,FOOTING DETAILS AS PER THE GIVEN DETAILS

PROCEDURE:

GO TO START MENU,SELECT INSTALLED AUTO CAD VERSION LIKE 2023.
CLICK ON START DRAWING.
GO TO CREATE NEW DRAWING.
THEN NEW TAB WILL OPEN AND IT SHOWS FOUR ICONS.
USE THE DEFAULT METRIC SETTINGS
OPEN THE TEMPLATE AS ACAD.DWT
THEN NEW DRAWING TEMPLATE IS CREATED AND SET THE LIMITS AND PRESS ENTER.
THEN WRITE ZOOMIN IN COMMAND TAB AND PRESS ENTER,TEMPLATE IS CREATED .
USING UNITS IN COMMAND TAB,SELECT THE UNITS YOU ARE GOING TO DRAFT.
WRITE LINE IN COMMAND TAB AND PRESS ENTER.
PLACING THE COLUMNS OF GIVEN SIZE ON SHEET.
PROVIDING BEAM OF 300MM *450MM OUTER FACE OF THE PLAN.
PROVIDING COLUMN OF 450MM*450MM.
DRAWING FOOTING OF 1800MM*1800MM AND INSERTING THE COLUMN IN CENTRE OF FOOTING BY USING OFFSET COMMAND .
THUS FOOTING PLAN IS ALSO CREATED.

RESULT:BY FOLLOWING THE ABOVE PROCEDURE THE BEAM FRAMING PLAN,FOOTING PLAN,COLUMN LAYOUT IS OBTAINED.

Ship work like this
in your own course.