Creation of geometries by Coordinate system methods using AutoCad

AIM : I NEED TO CREATE THE ABOVE GEOMETRIES THROUGH ANY OF THE CO-ORDINATE SYSTEM METODS.

INTRODUCTION : FIRST I OPENED THE AUTO CAD SOFTWARE.BEFORE DRAWING THE GIVEN GEOMETRIES IN AUTO CAD SOFTWARE,WE HAVE TO OPEN NEW DRAWING IN AUTO CAD ICON ,AFTER THAT A PAGE WILL DISPLAY AND IT ASKS ABOUT TEMPLATE YOU ARE GOING TO USE AND IT ALSO SHOWS UNITS YOU ARE GOING TO USE TO DRAFT THE GEOMETRY.

REQUIREMENTS AND EXPLANATIONS : AS WE DISCUSSED IN THE INTRODUCTION PART,BY APPLYING THE ABOVE TOOL TO DRAFT THE FIGURE WHICH IS IMPERIAL TEMPLETE.

1. WE USE LINE COMMAND TO DRAFT ANY GEOMETRICAL FIGURE.
2. BY USING THE RELATIVE CO-ORDINATE SYSTEM,WE JOIN THE TWO POINTS BY WRITTING LINE COMMAND.
3. IF WE TAKE THE GEOMETRY P-1 ,WE HAVE TO FIX THE FIRST POINT BY ENTERING CO-ORDINATES(2,1) AND WE GO FOR NEXT POINT BY ENTERING 6UNITS HORIZONTALLY AND IT TAKES TO NEXT POINT.
4. MOVING VERICALLY 1UNIT FROM THE PREVIOUS POINT.
5. MOVING HORIZONTALLY IN NEGATIVE X DIRECTION BY ENTERING -5 IN COMMAND LINE.
6. MOVING VERICALLY 4 UNITS.
7. MOVING 5UNITS IN HORIZONTAL X DIRECTION.
8. MOVING 1UNIT VERTICALLY.
9. MOVING 6UNITS IN NEGATIVE X DIRECTION.
10. BY PRESSING CLOSE OPTION APPEARED ON COMMAND TAB ,LINE JOINS WITH INITIAL POINT

RESAULT : BY FOLLOWING THE ABOVE PROCEDURE ,WE GET THE REQUIRED DRAFTED GEOMETRICAL DIAGRAM.