Drafting of various geometries using Chamfer, Fillet tool in AutoCad

AIM : DRAFTING OF VARIOUS GEOMETRIES USING CHAMFER,FILLET TOOL IN AUTO CAD.

INTRODUCTION:USING AUTO CAD SOFTWARE BY USING CERTAIN COMMANDS AND SETTINGS TO DRAFT THE GIVEN GEOMETRIES.

PROCEDURE:

STARTING AUTO CAD SOFTWARE

• GO TO START MENU,SELECT INSTALLED AUTO CAD VERSION LIKE 2023.
• CLICK ON START DRAWING.
• GO TO CREATE NEW DRAWING.
• THEN NEW TAB WILL OPEN AND IT SHOWS FOUR ICONS.
• USE THE DEFAULT IMPERIAL (FEET AND INCHES) SETTINGS
• OPEN THE TEMPLATE AS ACAD.DWT
• THEN NEW DRAWING TEMPLATE IS CREATED AND SET THE LIMITS AND PRESS ENTER.
• THEN WRITE ZOOMIN IN COMMAND LINE AND PRESS ENTER,TEMPLATE IS CREATED .
• USING UNITS IN COMMAND TAB,SELECT THE UNITS YOU ARE GOING TO DRAFT.
• FROM THE GIVEN 1ST QUESTION,USING LINE COMMAND, KEEPING IN ORTHO MODE,PUT THE POINT SOMEWHERE ON THE DISPLAYED PAGE.
• IT ASKS FOR NEXT LINE BY ENTERING 3UNITS IN COMMAND LINE AND PRESS ENTER.
• PUTTING THE CURSOR IN THE PREVIOUS POINT,PUTTING OFF ORTHO MODE AND ENTERING LENGTH AND ANGLE FORMAT AS @2.12<45.
• THEN THE NEW POINT IS OBTAINED AND LINE IS CREATED.
• KEEPING THE CURSOR ON PREVIOUS POINT ,AND IASKS NEW POINT WRITE AS @2.83<135.
• NEW LINE IS CREATED,KEEPING IN ORTHO MODE,MOVING HORIZONTALLY WITH 2UNITS.
• AND KEEP DRAWING THE INITIAL POINT AND CURRENT POSITION POINT.
• TO DRAW CIRCLE USING C IN COMMAND LINE.
• USING OFFSET COMMAND,MOVING INITIAL LINE WITH OFFSET DISTANCE OF 1 UNIT MOVING VERTICALLY.
• USING SAME COMMAND MOVING VERTICAL LINE HORIZONTALLY WITH OFFSET DISTANCE OF 1.5 UNITS.
• BY INTERSECTION CENTRE IS CREATED,USING C IN COMMAND LINE AND IT ASKS RADIUS AND ENTER 0.6 UNITS.
• THAT IMPLIES CIRCLE IS CREATED.

RESULT :BY USING THE ABOVE PROCEDURE THE GIVEN GEOMETRICAL FIGURE IS OBTAINED.