Creating a Floor plan, Footing detail and Isometric view using AutoCad

AIM : I NEED TO CREATE THE ABOVE FIGURES USING AUTO CAD SOFTWARE.

INTRODUCTION : FIRST I OPENED THE AUTO CAD SOFTWARE.BEFORE DRAWING THE GIVEN IN AUTO CAD SOFTWARE,WE HAVE TO OPEN NEW DRAWING IN AUTO CAD ICON ,AFTER THAT A PAGE WILL DISPLAY AND IT ASKS ABOUT TEMPLATE YOU ARE GOING TO USE AND IT ALSO SHOWS UNITS YOU ARE GOING TO USE TO DRAFT THE FIGURE.

PROCEDURE AND EXPLANATIONS : AS WE DISCUSSED IN THE INTRODUCTION PART,BY APPLYING THE ABOVE TOOL TO DRAFT THE FIGURE WHICH IS IMPERIAL TEMPLETE.

1. WE USE LINE COMMAND TO DRAFT ANY TYPE OF FIGURE.
2. BY USING THE LINE COMMAND,WE PLOT THE FIRST POINT AND IT ASKS NEXT POINT WHERE U HAVE TO PUT MENTION IT AS 0.9 MTS.
3. THE CURSOR TAKES TO NEXT POINT AND BY USING OFFSET COMMAND WE CREATE RECTANGLE FIGURE.
4. BY DRAWING ANOTHER LINE AT CORNER POINT BY GIVING 0.4 MTS HT FOR SIMPLICITY.
5. USING OFFSET COMMAND WE MOVE THE ABOVE LINE BY 0.2MTS TOWARDS RIGHT SIDE.
6. USING THE SAME COMMAND WE SHIFT THE ABOVE LINE BY 0.5MTS TOWARDS RIGHT SIDE.
7. USING THE LINE COMMAND WE DRAW HORIZONTAL LINE BY GIVING 0.05UNITS AND MOVING VERTICALLY 0.6 UNITS.
8. FROM THE PREVIOUS POINT WE DRAW THE VERTICAL LINE BY GIVING 1MT VERTICALLY.
9. USING THE COPY COMMAND,WE SHIFT THE LINE ON OTHER SIDE.
10. CLOSING THE TWO LINES BY ORTHO MODE.

RESAULT : BY FOLLOWING THE ABOVE PROCEDURE ,WE GET THE REQUIRED DRAFTED DIAGRAM.