Fender Design Challenge

Fender Design Challenge

INTRO:

Fender is the American English term for the part of an automobile, motorcycle or other vehicle body that frames a wheel well (the fender underside). Its primary purpose is to prevent sand, mud, rocks, liquids, and other road spray from being thrown into the air by the rotating tire. It also serves the fuction as a protection to pedestreants in an event of accident.

Mainly two types of fenders are found, full and half fende. Half fenders are commonly used as it uses much less materials.

The main 5 mounting pos are bumper mount, drip mount, A-piller mount, sill mount , baffle mount.

below are few image of fender:

AIM:

To create a solid fender design with required parameters.

1.Bumper mount

The section which joins bumper to the side front fender.functions used to ccreat the structure are law extention,projection of curve on extention , emboss and trimm sheet.

2.Drip

one of the most important section in mounting fender. structure is made with minimun safty requirmrnt, emboss law extention ,trimsheet.

3.A-piller

section which connects fender to A-piller.

4.Sill mount

sillmount connects fender to the floor of the vehicle. one of the main support for the fender. commands used are sheet extent, sketch projection,emboss, trimsheet and edge blend.

5.Baffel mount

Baffle mount is mounting hole to place baffle structure , to protect debries from hitting engine components. command used are sketch projection, trimsheet.

complete view:

front:

rear:

note:

The file has been atached as compressed file