Creation of geometries by Coordinate system methods using AutoCad
P-1:
AIM:Create the geometries from P1 to P2 using all the coordinates system methods.
PROCEDURE:
- Enter L in command bar.
- Give coordinates (2,1) then specifies automatically first point.
- Drag cursor to right and enter 6, top enter 1 .
- Similarly drag left enter 5 ,drag top enter 4, drag right enter 5 , top 1,left 6 and finally join the P1(2,1).
RESULT:
P-2:
AIM:Create the geometries from P1 to P2 using all the coordinates system methods.
PROCEDURE:
- Enter L in command bar.
- Give coordinates (2,1) then specifies automatically first point.
RESULT:
P-4:
AIM:Create the geometries from P1 to P2 using all the coordinates system methods.
PROCEDURE:
- Enter L in command bar.
- Give coordinates (2,1) then specifies automatically first point.
RESULT:
P-5:
AIM:Create the geometries from P1 to P2 using all the coordinates system methods.
PROCEDURE:
- Enter L in command bar.
- Give coordinates (2,1) then specifies automatically first point.
RESULT:
P-7:
AIM:Create the geometries from P1 to P2 using all the coordinates system methods.
PROCEDURE:
- Enter L in command bar.
- Give coordinates (2,1) then specifies automatically first point.
RESULT:
P-8:
AIM:Create the geometries from P1 to P2 using all the coordinates system methods.
PROCEDURE:
- Enter L in command bar.
- Give coordinates (2,1) then specifies automatically first point.
RESULT:
P-9:
AIM:Create the geometries from P1 to P2 using all the coordinates system methods.
PROCEDURE:
- Enter L in command bar.
- Give coordinates (2,1) then specifies automatically first point.
RESULT:
P-10:
AIM:Create the geometries from P1 to P2 using all the coordinates system methods.
PROCEDURE:
- Enter L in command bar.
- Give coordinates (2,1) then specifies automatically first point.
RESULT:
T-1:
AIM:Draw the profile and the trusses using any coordinate system methods.
PROCEDURE:
- Enter L in command bar.
- Give coordinates (0,0) then specifies automatically first point.
RESULT:
T-2:
AIM:Create the geometries from P1 to P2 using all the coordinates system methods.
PROCEDURE:
- Enter L in command bar.
- Give coordinates (0,0) then specifies automatically first point.
RESULT:
T-3:
AIM:Create the geometries from P1 to P2 using all the coordinates system methods.
PROCEDURE:
- Enter L in command bar.
- Give coordinates (1,1) then specifies automatically first point.
RESULT:
