Advanced Sheet Metal Design Using NX Cad Challenge_7_ Metal bracket-II

BRACKET-ll

OBJECTIVE:- To create a Bracket using a different sheet metal commands that will help to know about every single command in detail.

INTRODUCTION:- In this project we will learn about the step by step procedure to create Bracket from the given 2d Drawing.

DESIGN METHODOLOGY :-

This is the approch that show in the part navigater which command did we do first and then which one

Part Navigater

DESCRIPTION:-

To make the sheet metal Bracket these commands are used :-

Contour Flange:- This command is used to create a base feature by extruding a sketch along a vectore or add material by sweeping a sketch along an edge or chain of edge.

Contour Flange
Normal cutout:- This command we use to cut the sheet metal parts.

Normal cutout
Break Corners:- This command is used for cutting the sharp corners or edges because on the sharp corners at the stress level is high that's why the sharp corners brake eassily to prevenrt the corners we used break command .

Break Corners
Unbend:- This command used for to unfold the part.

Unbend
Normal cutout:- This command we use to cut the sheet metal parts.

Normal cutout
Rebend:- This is used to unfolded part to make folded part.

Rebend

Advanced Flange:- This command is used to add a flange along an edge using a bend angle or a reference face. the edge and refrance face can be curved.

Advanced Flange

Hole:- This command is use to make the diffront types holes.

Hole
Gusset:- This command is used to create a stiffening gusset on the part.

Gusset
MODEL REPORT:-

Top View

Front View

Side View

Isometric View

DETAILED DRAWING:-

DETAILED DRAWING

Flat-pattern

Drafting Sheet

CONCLUSION:- In this project we learn the step by step procedure to create Bracket from the given 2d Drawing.