3D Creation of Celing, Roof, Architectural plan, Structural plan, Sectional view, Elevation view and Camera specific view for a house plan using REVIT
1. Aim: Based on the project saved from Week 3, proceed from the First Floor Level. Model a Ceiling from the architecture tab above the walls at the first-floor level.
Conclusion:
2. Aim: Model a roof above the ceiling by selecting the footprints of the ceiling. Using the adjustment toolbars appearing on-screen adjust the roof slope to 10 degrees.
Conclusion:
3. Aim: Using the file saved from weeks 2 to 4, create plan views for ground floor level and first-floor level including all the walls, floors, and components. Separate them to architecture and structural plans.
Conclusion:
architecture plan:
structural plans:
architecture plan:
structural plans:
4. Aim: Using annotate toolbar add dimensions to all the walls and floors with reference to the longitudinal and transverse grids created in the project file.
Conclusion:
5. Aim: Create a sheet template from the view tab and adjust the parameters on the sheet to add appropriate views.
Conclusion:
6. Aim: Using the elevation tab create the elevation views, looking at your building from East, North, South, and West.
Conclusion:
East:
North:
West:
South:
7. Aim: Produce section cut through each room either cutting across longitudinally or in a transverse direction.
Conclusion:
Bed Room:
Dinning:
Kitchen:
Living:
Master Bed Room:
Toilet:
8. Aim: Classify the views, Plan Views, Section Views, and Elevation views to either Design or Documentation category using Properties browser.
Conclusion:
Plan View:
Section Veiw:
Elevation Veiw:
9. Aim: Using the sheet template produced create multiple sheets.
Conclusion:
A 101- Ground Floor Architecture Plan
A 103- Roof Plan
S 101- Ground Floor Structural Plan
S 103- Roof Framing Plan
A-201- North-South Elevations
A-202- East-West Elevations
10. Aim: Create a camera-specific view or a 3D view in each room.
Conclusion:
