DRAFT ANALYSIS:          VARIOUS ORIENTATIONS VIEWS:      

DESIGN AND DRAFT ANALYSIS  OF SWITCH BAZEL Aim: This project aims to create a Switch Bezel plastic component using the given class asurface following the OEM standard and Draft Analysis. Class A- Surface  First, the given styling surface is checked for any irregularities and if found any then it is corrected by using Trim,…

BUMPER DESIGN AIM: to make a model from the provided class-A surface.INTRODUCTION:CLASS-A SURFACE: a surface made by the designer which is given as an input to the plastic modeler to work on. It is aesthetic surfaceand the outer most surface.CLASS-B SURFACE: a surface below a certain thickness from the class-A surface…

Attachment Feature Creation (Ribs & Screw Boss) - Challenge 1 AIM Create the rib for the Drill Handle considering the design rules. INTRODUCTION Ribs and screw bosses are engineering features which are created on the B side of the plastic components. RIBS Ribs are used to strengthen the walls of your mould without…

Attachment Feature Creation - Challenge 2   AIM Create the Dog House for the Door Trim considering the design rules   INTRODUCTION DOG HOUSE Dog house is an engineering feature used in plastic design. Dog houses are used as support feature. Sometimes other engineering features like snaps, locators, screw bosses…

HOOD DESIGN OBJECTIVE    Design outer panel with the hem, develop the Inner Panel, develop all the necessary Reinforcements, Mirror and position the Hinge & Striker, provide Mastic Data, and provide the required Emboss definition. ABOUT HOOD    Hood is an important component of the front portion…

Aim: To find the section modulus of the hood and optimization to improve the overall section modulus.   Objective: Use the section from your Hood design and calculate the section modulus using the formula S= I/y.   Section Modulus: The section modulus (S) is geometry property of the cross section used for designing…

DESIGN OF CAR FENDER Fender is  the part of an automobile, motor cycle or other vehicle body that frames a wheel well (the fender underside). Its primary purpose is to prevent sand, mud, rocks, liquids, and other road spray from being thrown into the air by the rotating tire. Fenders are typically rigid and can be damaged…

CAR BACK DOOR DESIGN Aim: To design back door of car using given outer class 'A' surface. What is back door of a car? A door which is located at the rear side of a car which gives access for the boot space to store luggage, spare wheel etc. These doors can be operated manually or electric powered. In most of the luxury…

What is a Butterfly Valve? A butterfly valve is a quarter-turn valve that regulates flow. Key components: - Body - Disk (Plate) - Stem - Seat - Actuator or Handle

S K THAKURROOF DESIGN PROJETCSAIM / OBJECTIVE: For the given roof styling. Create an ASSEMBLY by developing the essential flanges for the outer roof and creating the reinforcements.Provide appropriate dimensions and check for Draft analysis.Do a curvature study on the roof and perform calculations to determine the…