INTERNAL GENEVA MECHANISM   AIM: To create the 3D model of the internal Geneva mechanism. To create 3D models for driver and driven…

                                                          PLANETARY GEAR   AIM: To analyze the motion analysis on a planetary gear under given conditions and explain…

                               MULTI BODY DYNAMICS SIMULATION ON A PISTON ASSEMBLY   AIM:  Model all the parts of the piston and then assemble them in SolidWorks. The motion analysis is going to be carried out in three different conditions …

                                             MBD Simulation on IC Engine Valve Train   AIM: Model the parts and assemble them in SolidWorks.  Obtain the valve Lift.  The contact force between …

                                                         FLOW OVER A CYLINDER   AIM: Calculate the baseline case Reynolds number.  Run a baseline simulation and then…

                                               FLOW OVER AN AEROFOIL   AIM: Model the flow over a NACA0017 airfoil. For the angle of attacks 0,2,4,6,8,10 compare the lift and drag forces. THEORY:…

                            MODELING AND SIMULATION OF FLOW-THROUGH A FLOWBENCH    AIM: For this project, you will create a 3D model of a flow bench and run flow analysis. You will be obtaining a plot of lift vs mass flow rate. You need…

                                                CENTRIFUGAL PUMP DESIGN AND ANALYSIS   AIM: To design and analyze the centrifugal pump at different outlet velocities. To obtain the relationship…

                JET DECAY CHARACTERISTICS OF CONVERGENT NOZZLE FOR UNCONTROLLED JETS   AIM: To find the jet decay characteristics of the convergent nozzle for free jets at Mach 0.6, 0.8, and 1.      Do the following steps: Grid dependency test To validate the…

                                                Frequency Analysis of a rotating shaft   AIM: To find out the critical frequencies of a rotating shaft in Solidworks. To create the model in Solidworks…

                                 PIPE FLOW SIMULATION USING SOLIDWORKS   AIM: To Run a pipe flow simulation with an inlet Reynolds number of 100,1000 and 10,000. To Place line probes at 95%, 90%, and 85% of the pipe length. To Compare…

                     ANALYSIS OF BUCKLING PHENOMENA OF CYCLONE SEPERATOR STAND   AIM: To perform a buckling analysis on a cyclonic separator stand without stiffener Create a metallic stiffener on the legs of the stand and run the analysis to find out the change…

                            Analysis on a plate with a hole   AIM: To perform a static analysis on two models of the plate with holes. To create the model in Solidworks and perform the analysis. Apply a fixed relation to one of the short side…

                                        PV Diagram and thermal efficiency of the Otto Cycle using MATLAB   Objective: To write code in MATLAB to plot the PV Diagram for Otto cycle and calculating the thermal efficiency…

                                                  Solving second order ODE  for Pendulum Motion   AIM: A program to simulate the transient behaviour of a simple pendulum and to create…

                  Genetic algorithm using MATLAB to calculate global maxima of a stalagmite function   AIM: To optimize the stalagmite function and find the global maxima of the function. THEORY: Genetic Algorithm (GA) is a search-based optimization technique based on the…

                                                     Parsing NASA thermodynamic data   AIM: To write a MATLAB program to parse the NASA thermodynamic data file. Calculate the thermodynamic…

                                                     Image processing using MATLAB   AIM: To perform image processing by using the Matlab Editor window. To perform image processing…