The section modulus using the formula S = I/y S = Section Modulus I = Moment of Inertia Y = distance between the nuteral axis and the extreme end of the object  Consider Stainless steel AISI 302 – cold-rolled – y = 520 MPa.   ORIGINAL HOOD DESIGN   Section Modulus is directly…

https://drive.google.com/open?id=1MWwsdenytqp3WJR5HKyJ8aEC9TNZ4HWg  

Automobile Roof An automobile roof or car top is the portion of an automobile that sits above the passenger compartment ,protecting the vehicle occupants from sun, wind, rain, and other external elements. Because the earliest automobiles were designed in an era of drawn carriages, early automobile roofs used…

 MODELING AND ASSEMBLY OF YACHT USING SOLIDWORKS                                                                    Chapter 1      …

https://drive.google.com/open?id=1RENUpc0hQZmKxJXFbgv-U8GxQz-EIzJs  

https://drive.google.com/file/d/106S5rv7RdreY0huPeUPMNtXzn9kqPqPp/view?usp=sharing  

AIM : To design a ‘Sheetmetal Box Assembly’ using Siemens NX Sheetmetal Application.

  1. Transmission belt   2. Kickstand   3. Front fender   4. Rear fender  

                                                                                           …

European Regulation Requirement for Wheel Arc:   PROCEDURE: Sketch was created on the plane of tire:   Measuring SA:                    Clearence measured = 9.9490mm (FAIL) Measuring SB:                      …

                   MODELING AND ASSEMBLY OF AMERICAN CHOPPER USING                                         SOLIDWORKS              …

https://drive.google.com/file/d/1I5f50x6yjeVup-ILercc9wEB2KevNaIs/view?usp=sharing

Hood (car) The hood  or bonnet  is the hinged cover over the engine of motor vehicles that allows access to the engine compartment, or trunk on rear-engine and some mid-engine vehicles) for maintenance and repair. In British terminology, hood refers to a fabric cover over the passenger…

AIM : The objective here is to design the Drip Area, Sillmount area, bumper mount region and A-pillar mount Region.

AIM: To design a ‘Sheetmetal Casing’ using Siemens NX Sheetmetal Application.

Based on  Mr . D.S. Pughazhyendhii  requirements .... For daily usage and for long drive diesel cars are better with fuel economy. And also He is fond of big cars.  I mention the following cars based on his requirements. And also in upcomming years HYBRID ELECTRIC CARS are also available. I suggest him to…

  1) What is under body coating?        Underbody Coating (UBC) is a plastisol that is a shear-thinning paste, which is applied to the       vehicle in the paint shop. UBC is applied on the underside of the vehicle and in the wheel wells.       Once curing…