American Chopper Rear Wheel and Front Fork

 MODELING AND ASSEMBLY OF YACHT USING SOLIDWORKS                                                                    Chapter 1      …

                   MODELING AND ASSEMBLY OF AMERICAN CHOPPER USING                                         SOLIDWORKS              …

Hood (car) The hood  or bonnet  is the hinged cover over the engine of motor vehicles that allows access to the engine compartment, or trunk on rear-engine and some mid-engine vehicles) for maintenance and repair. In British terminology, hood refers to a fabric cover over the passenger…

Automobile Roof An automobile roof or car top is the portion of an automobile that sits above the passenger compartment ,protecting the vehicle occupants from sun, wind, rain, and other external elements. Because the earliest automobiles were designed in an era of drawn carriages, early automobile roofs used…

https://drive.google.com/open?id=1MWwsdenytqp3WJR5HKyJ8aEC9TNZ4HWg  

https://drive.google.com/open?id=1RENUpc0hQZmKxJXFbgv-U8GxQz-EIzJs  

https://drive.google.com/file/d/106S5rv7RdreY0huPeUPMNtXzn9kqPqPp/view?usp=sharing  

https://drive.google.com/file/d/1I5f50x6yjeVup-ILercc9wEB2KevNaIs/view?usp=sharing

  1. Transmission belt   2. Kickstand   3. Front fender   4. Rear fender  

                                                                                           …

 The section modulus using the formula S = I/y S = Section Modulus I = Moment of Inertia Y = distance between the nuteral axis and the extreme end of the object  Consider Stainless steel AISI 302 – cold-rolled – y = 520 MPa.   ORIGINAL HOOD DESIGN   Section Modulus is directly…

AIM : The objective here is to design the Drip Area, Sillmount area, bumper mount region and A-pillar mount Region.

European Regulation Requirement for Wheel Arc:   PROCEDURE: Sketch was created on the plane of tire:   Measuring SA:                    Clearence measured = 9.9490mm (FAIL) Measuring SB:                      …

  1) What is under body coating?        Underbody Coating (UBC) is a plastisol that is a shear-thinning paste, which is applied to the       vehicle in the paint shop. UBC is applied on the underside of the vehicle and in the wheel wells.       Once curing…

Based on  Mr . D.S. Pughazhyendhii  requirements .... For daily usage and for long drive diesel cars are better with fuel economy. And also He is fond of big cars.  I mention the following cars based on his requirements. And also in upcomming years HYBRID ELECTRIC CARS are also available. I suggest him to…

AIM : To design a ‘Sheetmetal Box Assembly’ using Siemens NX Sheetmetal Application.

AIM: To design a ‘Sheetmetal Casing’ using Siemens NX Sheetmetal Application.