Section modulus It is geometrical property used for cross section calculation for designing structures and members. It is the ratio of total moment of inertia resisted by the section to the extreme fibre  or the farthest point (as maximum stress could cause failure at the point), it is also yield stress A beam that…

Designing and Modeling the Front Fender of a car Objective To design and model a front fender of a car with drip area, sill, cowl and bumper attachment Introduction The front fender is mainly to protect engine compartment and pedestrians from chipping. Front fender is of two types half bumper type and full bumper type…

Modeling a Yacht Objective To create a 3d cosmetic model of a Yacht using Solidworks and render it with photoview 360 Introduction The modelling of Yacht involves 3 stages Modelling of individual parts Assembling of the parts Rendering the components             The…

Analysis of wheel arc radius of a fender Objective To inspect the wheel arc for the given fender and compare values of the fender with the base standard values. Introduction Wheel arc is an important factor as it plays a major role in pedestrian safety. Because when the automobile is in motion then the due to the chipping…

Roof is an important part of automobile as it protects passenger from various environmental factors and climatic conditions. It also acts as a safety gear when a roll-over accident occurs. Design criteria for roof Visibility Head clearance Heat distorsion Snow load Curvature study The roof is designed in such a way that…

Objective To model the inner panel of the back door of a car using catia V5 with necessary embosses and reinforcements Introduction Back door is the rear most part of a car. It is a critical component to design and model because it has to be strong enough for sustain the rear crash. The car back door consists of the following…

Modeling of American chopper Objective To create a model of an American Chopper using Solidworks and render it with photoview 360 and SolidWorks visualize Introduction The modeling of American Chopper involves 3 stages Modeling of individual parts Assembling of the parts Rendering the components The American chopper consists…

Designing and Modeling the hood of a car Objective To model the hood of a car with using Catia V5 with necessary embosses, mastic points to fulfil the pedestrian safety requirements Introduction Car hood is also called as bonnet or engine cover. It a critical component to design and model because it has to be strong and…

Drive link: https://drive.google.com/file/d/1AqnLwQyKNrDvipHs9CswF-C3qoe-8C2k/view?usp=sharing  Figure shows the 2D drawing created from the 3D model using Part design work bench

Drive link: https://drive.google.com/file/d/1PisAvNV6zv6o8xo83Px2g0thXzjYklaV/view?usp=sharing  From the given class A surface of the door arm rest, class B and class C surface are created and is converted into a solid of thickness 2.5mm Figure 1 shows the door arm rest with main tooling axis and two sliding…

Drive link: https://drive.google.com/file/d/1Urpw4UhYQ8vqx-fkUzR7Zs3RhyC_GlWz/view?usp=sharing  class A surface of the interior of an automotive door is given and aim of the project is to create the class B and class C surface with respect to tooling axis The given plastic parts are arm rest lower substrate bottle…