Wiring harness routing & packaging Rules Week 3 Challenge

Answer1:-

p-clamp:-

Create a point for entry plane:-

Create a point for exit plane:-

Creating plane:-

Create base plane:-

Define as electrical support

Switch in to electrical part design

Click define support and click the clip

Entry, exit and base of the clip are defined 

There are two entries and two exists are available

Defining the second:-

Hide all the planes:-

Above figure shows that the properties are stored and the clip is ready to use.

Answer 2:-

As shown in below figure backshell connection point and bundle connection point is created.

Switch in to electrical part design.

Define backshell

Define backshell connection point.

Define bundle conection point.

Below figure shows that the properties are stored and the part is ready to use.

Answer 3:-

To create corrugated tubes

Create new part → Switch to electrical part design → Select Define protection part.

Create catalogue document and add the corrugated tubes into the Catalogue under “Slit COT” family.

Add all the corrugated tubes in to the above created catalogue.