Wiring harness design in CATIA V5 - 3D modeling Week 7 Challenge
AIM_ Flatten the harness assembly given in week challenge 4 Place all the flattened view on drawing sheet. Ensure bundles with protective coverings has different visuals on drawing view.
Download connector 3D data from www.te.com
Reference Data
- DT06-4S
- DT06-6S
- DT06-2S
- DT06-08SA
We have given connector downloaded by the website, In given pictures connectors are fully defined with connector connection point and bundle connection point representations. 
Connectors catalogue:-
A given connector is fully electrically defined and saved in the catalog. 
- The given pictures shown about wiring harness routing design and its fully defined electrical connectors, bundles & protective covering representations.
- The dimeter of bundle is prescribed in between 5 & 10 MM hence COT tubes 10 and 15 mm are used as shown in the given pictures.
- To design wring harness assembly in electrical wring harness assembly in CATIA V5 in that the product is defined by geometric bundle design for that below is the given representations of wring harness bundle design
- The wring harness routing representation given below.
Flattened view
- The given challenge 4 wiring harness is use for wiring harness flattened drawing.
- The various commands is used for harness flatten,
Conclusion_ In this we have successfully completed the wiring harness drawing exercise.