Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge

AIM- Route two electrical harnesses as per the given layout and interconnect them as a single harness assembly and then check for bundle continuity, bundle warnings, and then give annotations to the final harness assembly.

OBJECTIVE-

The objective of this project is to first route the two Harness A and Harness B as per the given harness layout.

Step-1:

Define all the electrical connectors geometrically and electrically so that they can be used in the wiring harness.

HARNESS A

After all the connectors are defined, the workbench was switched to Electrical Harness Assembly where Geometrical Bundle was activated. All the connectors were routed using the Multi-Branchable Document command.

HARNESS B

After all the connectors are defined, the workbench was switched to Electrical Harness Assembly where Geometrical Bundle was activated. All the connectors were routed using the Multi-Branchable Document command.

HARNESS ASSEMBLY

CONNECTIVITY CHECK

Check for both the harness

ANNOTATIONS