Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge
AIM
Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use Following connectors as shown in layout diagram.
Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end)
Download connector 3D data from www.te.com
- DT06-4S
- DT06-6S
- DT06-2S
- DT06-08SA
Let's download the data from open source given in input and define them into electrical component and also define the required features for the component.
- DT06-4S
- DT06-6S
- DT06-2S
- DT06-08SA
Now position all the connector at required location -
Now go to the harness assembly and create multi-branches -
Now add protective covering on all branches -
