Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge
Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use Following connectors as shown in layout diagram.
creating sketch
and added to the part design w/b
Download connector 3D data from
- DT06-4S
- DT06-6S
- DT06-2S
- DT06-08SA
then creating a point and the axis system and then
DEFINE THE ELECTRICAL PART FROM MCAD -ECAD
DEFINED PARTS AS A ELECTRICAL DEFINED
tree structure
Added protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end)
added a insulation tape for the branches.
final routing of added cot tube for protection.
added an extremity in the connector branches.
