Challenge

Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

Aim:

1) To Route the following harness layout in the Electrical workbench.

2) Add protective covering on all branches connected to DT06-2S & DT06-4S connectors.

3) Keep end extremity at 30mm (from connectors end)

4)Make assumptions for harness bundle diameters

Given:

CAD data of the following Connectors:

Convecting the Mechanical part design into the Electrical part design for that I followed the below steps

the connector is shown below

part name : c-dt06-2s-a-3d

part name : c-dt06-4s-a-3d

part name : c-dt06-6s-a-3d

part name : c-dt06-08sa-b-3d

REFERENCE ARE CREATED ON THE FRONT PLACE FOR YOUR EASY ARRANGING THE CONNECTORS IN THE GIVEN LAYOUT

LAYOUT IS CREATED NOW WE GOING TO ARRANGE OUR CONNECTOR IN AN GIVEN ORDER

NOW SWITCH TO ELECTRICAL HARDNESS ASSEMBLY AND CREATE THE MULT-BRANCHABLE SEGMENT

Ship work like this
in your own course.