Project 1

DOUBLE_ACTING_ACTUATOR_MODEL.

Mechanical configuration-set mechanical and simulation parameter that apply to an entire machines

Solver configuration-define solver setting to use for simulation

World frame-provide access to the world frame or general frame

MECHANICAL SYSTEM:-

Solidbricks-represent the solid combination or geometric an inertia and mass a graphical components and rigidity frame into a singal uint

Prismatic joint-reoresent thenprismatic joint two joint between the two frame

Transional multybody interface-this block ia an interface between a simscape multibody joint and simscape mevhanical transional netwrok

HYDRAULIC SYSTEM:-

Chamber blocks-this blocks model an interface b/w an isothermal liquid network and mechanical transional network it canbuilt a linear actuator

PS-Constant-this blocks create a physical signal constant

PS-Substract-this blocks perform subtract two input

Mechanical translational reference-this block are frame or graound

THERMAL CIRCUIT:-

Orific BT-the pressure loss due to a flow area restriction

Isothermal liqiud propertirs-provide isthermal liquid properties to the connected isothermal liquid network

Reservoir-the block set a constant boundary contion is an isothermal liquid network

Pressure source-mechanical energy to isothermal liquid network that cann be maintain pressure difference of the flow rate

Signal generator-to generate the singal to the input

Gota-recive the signal to the gota block to the sending the anther blocks

Scope-to simulate and diplay the simulation