Wiring harness design in CATIA V5 - 3D modeling Week 2 Challenge
Objective:-
To Download following connectors & Connector clip cad data from given link & define it as Electrical Connector using Electrical Part design Workbench. Define all the necessary properties to Connectors & Clip.
- Deutsch DT06 – 08SA ( https://www.te.com/usa-en/product-DT06-08SA.html)
- Tyco 174357-2 (https://www.te.com/usa-en/product-2-174357-2.html?source=header-match)
- Tyco 85229-1 – (https://www.te.com/usa-en/product-85229-1.html?q=85229&source=header)
PROCEDURE:
Typical design flow of EDS System.
Defining the Connector:-
We need to define the connector by following the below steps.
- Download the connector data from TE Website.
Image (1):-
- Create required geometrical parameter like Bundle entry point and Connector cavity axis in part workbench.
Image (2):-
- Define part as electrical connector and give all parameters value such as terminals and so on:-
Image (3):-
- Define bundle connection point and give all parameters like point,contact face:-
Image (4):-
- Define connector connection point and give all parameters like representation, contact and like-wise:-
Image (5):-
- Define cavity connection point which is present in electrical assembly design and purpose is that to mate mounting part as shown in below:-
Image (6):-
Defining the mounting clip
- Download the clip 3d data from TE Website :-
Image (1):-
- Define the part as mounting component in electrical part workbench.
Image (2):-
- Define the part as cavity.
Image (3):-
Defining the connector is described below
- Downloaded the cad data from the supplier's website and the images are shown below.
Image (1):-
- Create required geometrical parameter like Bundle entry point and Connector cavity axis in part workbench.
Image (2):-
- Define part as electrical connector and give Connector connection point of all parameters value such as terminals and so on:-
Image (3):-
- Define bundle connection point and give all parameters like point,contact face:-
Image (4):-
Assembly of Connector and mounting part as shown in figure:-
- First of all both the component insert into electrical Assembly design workbench.
- define the connecting electrical device and mate the Connector and mounting part.
Image (1):-
