Wiring harness design in CATIA V5 - 3D modeling Week 2 Challenge

Week 2 Challenge

Objectives:

1. Define connector as Electrical connector using Electrical Part design Workbench. Define all the necessary properties.
2. Define mounting clip as Electrical part using Electrical Part design Workbench. Define all the necessary properties.
3. Defining parts as an electrical part

Fig.1 creating a point

Fig.2 creating an axis system

Fig.3 fully defined geometrical parameters

Fig.4 defining connector-connection point

Fig.5 defining bundle-connection point

Fig.6 fully defined connector 1 as an electrical part.

Fig.7 fully defined connector 2 as an electrical part

Fig.8 defining cavity for mounting clip

Fig.9 fully defined mounting clip as an electrical part

2. Creating an electrical connection between two electrical devices

Fig.10

Fig.11

Fig.12 final electrically connected devices