Week 9 - Project - A pillar Design with Master Section

                                                                                         REPORT

                                                                        PLASTIC PRODUCT DESIGN

                                                                     A Pillar Trim with master section

OBJECTIVE: Design and develope A pillar trim with dog house by given class A surface with master section. Will creat class B and Class C surface and tooling axis using Bisecting methode.

PROCEDURE: The procedure to follow for developing or design plastic product model by using class A surafce are shown in below fllow chart:-

TOOLING AXIS: Tooling axis is the movement direction of the mould and cavity, so it is very important to creat the tooling axis for the plastic product model while design, to analys the draft angle effect for the product. For this model the tooling axis is created by using Bisectiong and normal to surface method. There are different type to creat tooling axis which is mention below:-

• Normal X,Y,Z
• Point and Direction
• Normal to Surface
• Side Core Axis
• Bisecting Method

First we have to analys the model and find the suitable position where the model shoule be perpendicular position to the tooling axis. By using bisecting option we have to creat line which is going to be our main tooling axis. For the side core axis we have to use normal to surface option for creating tooling axis for dog house.

Once the tooling axis is created we need to do draft analysis for the given class A surafce.

DRAFT ANALYSIS: It is very important to give draft angle to the plastic product to avoid damage or defective product output from the mould. The draft angle using in industries are 3 degree.

Drag the compus to the tooling axisand kept in center and then click on the compus icon on draft analysis dialogue box, the compus will get active. Once the compus will active again need to aligned along with tooling axis.

Once the compus aligned with tooling axis, click on the model to do the draft analysis, the model is convert into green color then its indicate model is perfect for modeling and if it is showing red in color then click on the draft analysis dialogue box in reverse icon and the model will get turn into green color, after click on reverse icon still the model is in red color the , don't proceed further , and revert back to class A surface engineer.

The below picture showing the draft analysis for the A Pillar Trim with master section:-

Draft analysis for final close surfce-

Draft analysis for final solid body-

B SURFACE: Once the draft analysis is over for the class A surface , next step is to creat B surface.Analysis the class A surface if the surface is less the proceed with multiple offset, if the class A surface is more surface which is difficult to offest one by one then we have to go for one time offet option.

For this model the number of surface is less , so multiple offset is use for offsetting for surface at given distance or if the distance is not given then we can assume 2.5mm or 3mm.

CLASS C SURFACE: The class C surface helps to connect the class A surface and B surface. The C surface is created with the reference of class A surface and tooling axis. When the class C surface is created we have to  give the proper angle, if the draft angle is not given then it will creat problem while moulding the product.

First we have to take the boundary for the class A surface edges and by suing swept commond , the C surface will developed. While developing C surafce we have to give proper draft angle to the surface.

Once th C surface is created then need to check the proper intersection of C surface and B surface. By joining and trimming common we have to join the C surface with the class A surface and after join need to trimmed the C surface from B surface, so at the ned we will get final close surface. Once the close surface will creat do the draft analysis for the close surface.

FINAL SOLID BODY: This ia the final stage of the plastic product model,where the final close surface will converted into a solid body.Once the final close surface is created we have to shift to part workbench from surface workbench. In part workbench by using close surface commond the close surface will converted in to solid body.

Once the solid body will created again do the draft analysis for the solid body.