Week 9 - Challenge 3 - Bumper

AIM:Create the Bumper Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

Take the Thickness of the component to be 3 mm

DRAFT ANALYSIS OF BUMPER FINAL

BUMPER CLASS A

THE BUMPER CLASS A WAS FIRST DOWNLOADED AND THEN THE MODEL WAS OFFSETED TO THE REQUIRED THICKNESS AND THEN THE MODEL IS MODIFIED TO CREATE THE CLASS B AND CLASS C SURFACES .