Week 9 - Challenge 3 - Bumper

AIM

To Create the Bumper Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

GIVEN

Thickness of the component to be 3 mm

DETAILED REPORT

• To open the given CLASS A SURFACE
• Insert a new geometrical set name it as CONSTRUCTIONS in this Geometrical set. we create TOOLING DIRECTION
• IN TOOLING DIRECTION Extract the base and create a point and draw al line.
• Create a new geometrical set Name as CLASS B SURFACE
• Offset the class A For 3mm
• Open multiple extract and select the required surfaces
• Create a boundary A nd extrapolate that boundary
• Trim that extrapolate
• After that Edge fillet to be use in sharp edges
• Create geometric sets CLASS C SURFACE
• CLASS C surface is to sweep the class A SURFACE
• Hide the CLASS B SURFACE
• UNHIDE CLASS A and CREATE BOUNDARY and use that boubdary with sweep option
• After that Extrapolate the sweep and TRIM THAT EXTRAPOLATE unnecessary things we got CLASS C SURFACE
• Create new geometrical set to Join CLASS A & CLASS C SURFACE
• Tim that class A & CLASS C SURFACE
• After that unhide Class B surface and TRIM that JOIN A&C surface
• Finall OUTPUT ready.

TREE STRUCTURE

CONSTRUCTIONS

TOOLING

CLASS B SURFACE

CLASS C SURFACE

JOIN CLASS A & CLASS C SURFACE AND FINAL TRIM

PUBLICATIONS

DRAFT ANALYSIS

CLASS A SURFACE

FINAL OUTPUT

VIEWS

ISOMETRIC VIEW

FRONT VIEW

SIDE VIEW

TOP VIEW

RESULT

Thus,the Bumper Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model to be completed.